Create a new “File_Sender_DS1” receiver communication channel. Error in the reply message — There is an error in this scenario, and the reply message stays in between, and the sender continues to wait. Recipient identification: – Determinator identifies one or more receivers for a specific combination of transmitter and outgoing interface. The image shows a graphic view of the recipient`s destination. Network Error – An error occurred in the communication network between the transmitter and the receiver. The sender is not aware of this and the message stays in between, and the sender waits for the execution time. Information Interface: – Message interfaces are three types – Outbound Interface, Inbound Interface and Abstract Interface. The sender and receiving agreement specifies how the IP system will cooperate with the third-party system. And it is used to specify the adapter used for connection with the respective systems. Transmitter and receiver agreements are required to assign or refer the transmitter or receiver`s communication channels. These are pi configuration objects.
Hope that helps. Enter your “CX1_Business_System” destination business system. record. Receiver identification: – Determinator identifies one or more receivers for a specific combination of transmitter and outgoing interface. The image shows a graphic view of the recipient`s determination. Communication channels: – We set the rules for processing messages during incoming or outgoing processing. A communication channel defines the type and configuration of the adapter used during inbound or outbound processing. Communication channels are defined in enterprise systems/services. There are two types of Communication Channel transmitter communication channels (which contains the configuration data of a transmitter adapter) and the receiver communication channel (contains the configuration data of a receiver adapter). The configuration of the communication channel is as follows. Information Interface: – Message interfaces are three types – Outbound Interface, Inbound Interface and Abstract Interface. Outgoing interfaces are used to communicate with XI, which receives messages from senders.
XI uses incoming interfaces to deliver messages to recipients. Abstract interfaces are used for communication between integration servers and ccBPM. Other interfaces can be classified as asynchronous and synchronized according to the message flow. (ICO is since PI7.11… If you use an earlier version, you need to create a transmitter/receiver agreement) The configuration of the communication channel is as follows. If there is an error, the sender must send a message again. In this scenario, the sender`s application is blocked until a response is received or a time error occurs. The adapter determines the payload of message XI based on its configuration. However, the information of the message head is determined from the corresponding broadcast agreement for the communication channel. SAP PI offers a wide range of adapters that allow you to connect applications from different protocols.
In the case of the sender, the adapter converts the incoming message coded in the sending protocol into a PI-SOAP message. In the case of the recipient, the PI-SOAP message is then converted to the recipient`s protocol. In this approach, the sender can re-send the message after a certain period of time, and there may be a double message. This ip approach is called BE (Best Effort). Business System/Service: – Business systems/services are logical senders or recipients who exchange messages and have entered the system landscape directory. The business systems in the systems landscape directory refer to a systemic landscape.